![wings 3d shell extrude wings 3d shell extrude](https://i.ytimg.com/vi/uITjZhXac0M/maxresdefault.jpg)
Select the two long edges on the front face and Cut by 3. Then Select the two vertices on the front face and Connect them as shown in Figure 10.e. You should have something similar to that shown in Figure 10.d. Select the two large faces, one on each side, and Extrude Normal by 1.0.
![wings 3d shell extrude wings 3d shell extrude](https://3dmarius.files.wordpress.com/2013/10/2013-10-04_m3_marius-aaslund_id24.png)
In (f) the new edge and the bottom edge were Cut by 3 and the resulting vertices then Connected. The vertices on the front face have been Connected in (e). Do both sides of the model at the same time to ensure symmetry. The new edge and the two side edges were then Connected in (b).
![wings 3d shell extrude wings 3d shell extrude](https://venturebeat.com/wp-content/uploads/2020/03/aiskinshine.jpg)
The top and bottom edges have been Connected in (a). You should have something similar to that shown in Figure 10.c.įigure 10. Simply stop dragging when the value reads 0.50 and left click the mouse. You can see the units change in the Status Bar at the bottom of the Wings window, below the Icon Bar. Then Move the vertical mid-edges forward in the Z direction on both sides by 0.50 units. Move the horizontal mid-edges up in the Y direction on both sides by 0.50 units. You should have something similar to that shown in Figure Hit the Space Bar to deselect the new edge. Select the three vertical edges on one of the sides. You should have something similar to that shown in Figure 10.a. Repeat the operation on the opposite side of the cube. Then Connect them (remember to right click to bring up the Edge menu). Select the lower and upper edge on one of the sides. Don't bother to save the tooth, unless you really want it. If you still have your finger exercise up, do a File New.